Hi, What I used when I tested to do a restore to a different RAID controller was to use a slip streamed w2k3 installation CD where all HP drivers were included. I had no problems and it should work if you follow the steps in the ASR Redbook.
HP DL380 G3, 5i Plus and 5312 controler. Backup 5i -> Restore 5i OK Backup 5i -> Restore 5312 OK Backup 5312 -> Restore 5312 OK Backup 5312 -> Restore 5i OK //Henrik -----Original Message----- From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] On Behalf Of Gottfried Scheckenbach Sent: den 13 juni 2005 14:01 To: ADSM-L@VM.MARIST.EDU Subject: Trouble - ASR on Win2003 - changed raid controller Hi all, does somebody know if asr recovery is possible in this case? ASR diskette and backupsets are ready! Do I have to change the asr disk to have the new driver included? >From my point of view: 1. Boot and Install from backupsets should be no problem because driver can be supplied in fist - nongraphics - boot phase 2. Boot of the installed System is the real problem because without changing the asr disk there is no driver to open the new raid controller Thanks, Gottfried ------------------------------------------------------------------- The information contained in this message may be CONFIDENTIAL and is intended for the addressee only. Any unauthorised use, dissemination of the information or copying of this message is prohibited. If you are not the addressee, please notify the sender immediately by return e-mail and delete this message. Thank you.
