Hi, I can tell you that during the single session restore it mounts ~15 tapes. Therefore, I suspect that the data is spread out (otherwise there would be no need to mount the other tapes).
The restore was started through the X-windows gui by selecting the filesystems to restore. They were restored to their original locations. Not sure what/how to do an NQR... Michael Wheelock Integris Health -----Original Message----- From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] On Behalf Of Curtis Stewart Sent: Monday, February 14, 2005 3:44 PM To: ADSM-L@VM.MARIST.EDU Subject: Re: AIX Restore Tim Wrote: "Is the node's active data spread out across all the tapes?" I think this is the key to the problem here. Just looking at the volume usage table doesn't really tell us where the active data lies. It may well be that the active data being restored is only on a subset of those tapes. [EMAIL PROTECTED] ************************************************************************************************** This e-mail may contain identifiable health information that is subject to protection under state and federal law. This information is intended to be for the use of the individual named above. If you are not the intended recipient, be aware that any disclosure, copying, distribution or use of the contents of this information is prohibited and may be punishable by law. If you have received this electronic transmission in error, please notify us immediately by electronic mail (reply). **************************************************************************************************
