Did the library load the cartridge in the correct drive? Make sure that the element number that you've defined for the drive /dev/mt1 is the right one for the location of the in the library.
What you're describing sounds very much like the way TSM acts if there is a mismatch between device name and element number. Drive device/element numbers do not necessarily stay constant when moving to new hardware.
Ted
At 07:58 AM 3/11/2004 +0200, you wrote:
Hi to all
After installing Aix version 5.2 (old version 4.3.3.1) and installing my Tsm version 5.1.8 (before upgrading to 5.2) when I run a :
dsmserv restore db devclass=dbbclass volumenames=000042
I got an error message unable to open media /dev/mt1 error=46
This command load the correct cartridge on the tape but after a while I got this message.
I try to change the blocksize on my mt1 device to : 1024 , 512 , 0 without any success the same error.
My robot is a Scalar1000 DLT40/80.
Any suggestions will be really appreciate ……
Regards Robert Ouzen E-mail: [EMAIL PROTECTED]
