Stefan, This isn't of much help but it has to be defined in the client add wizard of the operations center, if you define a node from the server CLI it defaults to 1. Adding a client using the OC you will notice on the console that it explicitly specifies 7 for the maxnummp parameter.
ANR2017I Administrator ##### issued command: REGISTER NODE TEST ?***? USERID=NONE TYPE=CLIENT AUTHENTICATION=LOCAL DOMAIN=FILE_DOMAIN DEDUPLICATION=SERVERONLY SSLREQUIRED=DEFAULT MAXNUMMP=7 I spent a considerable amount of time trying to figure out how to change it but so far have had no luck. -Rick Adamson -----Original Message----- From: ADSM: Dist Stor Manager [mailto:ADSM-L@VM.MARIST.EDU] On Behalf Of Schulz Stefan Sent: Wednesday, May 23, 2018 5:00 AM To: ADSM-L@VM.MARIST.EDU Subject: [ADSM-L] Change MAXNUMMP Value for Registering Nodes in OC * This email originated outside of the organization. Use caution when opening attachments or clicking links. * ---------------------------------------------------------------------- Hi all, does anybody know if it is possible to change the default MAXNUMMP-Value which is used to register Nodes via Operations Center? It always uses MAXNNUMMP=7, I'd like to change it to 8, if possible. I know I can change it afterwards, but then I can do registering via command line anyway... Best Regards, Stefan Schulz System Engineer - IBM Competence Center CANCOM GmbH **CONFIDENTIALITY NOTICE** This electronic message contains information from Southeastern Grocers, LLC and is intended only for the use of the addressee. This message may contain information that is privileged, confidential and/or exempt from disclosure under applicable Law. This message may not be read, used, distributed, forwarded, reproduced or stored by any other than the intended recipient. If you are not the intended recipient, please delete and notify the sender
