Hello, Ben! Are you trying to define this as a MANUAL drive? If so, then
checkin libvol is invalid for MANUAL drives. You have to manually issue the
query request and reply commands & physically mount the volume in the drive
itself!
Also, insufficient mount points are due to either your MOUNT LIMIT from
define devclass is not set to the appropriate number of drives or your max
scratch is not high enough!
Thanks,
Demetrius
-----Original Message-----
From: Ben Kokenge [mailto:[EMAIL PROTECTED]]
Sent: Monday, February 19, 2001 12:19 PM
To: [EMAIL PROTECTED]
Subject: Check in manual lib. error.
Hello *SMers,
I was trying to set up an external single DLR drive to my ADSM 3.1.50
system. I created all devices and pool, but keeps giving me this message:
ANR0535W Transaction failed for session 2293 for node DLT.TEST (WinNT) -
insufficient mount points available to satisfy the request.
I labeled the dlt tape ok, but I could not check it in with this error:
adsm> checkin libv dltlib vol001 status=scr
ANR8403E CHECKIN LIBVOLUME: Operation not allowed for MANUAL libraries.
ANS8001I Return code 3.
So I just defined it into that pool, but when I try to use it i get:
ANR0535W insufficient mount points available to satisfy the request.
I think I need a scratch volume in there, but I can't figure it out. I have
max scratch set to 3 for that pool.
Any help?
ben
info below:
DEV CLASS:
Device Class Name: DLT
Device Access Strategy: Sequential
Storage Pool Count: 1 <--- (defined vol in there)
Device Type: DLT
Format: DLT35C
Est/Max Capacity (MB): 35,840.0
Mount Limit: 1
Mount Wait (min): 60
Mount Retention (min): 60
Label Prefix: ADSM
Library: DLTLIB
I created drive:
Library Name: DLTLIB
Drive Name: DLTDRV
Device Type: GENERICTAPE
Device: /dev/rmt0
ON LINE: Yes
Element:
Library Name: NONE
I created lib:
Library Name: DLTLIB
Library Type: MANUAL
Device:
Private Category:
Scratch Category:
External Manager:
