Holy smokes! I figured out why the database was never upgraded...
when you do the install about 3/4 of the way through it comes up with
something about Active Directory and it says you need to restart your
computer, do you want to do it now y/n... the first time I ran the
installation I answered yes... this crapped out the rest of the install. I
just re-ran the 4.1.0.0 install and answered no to the reboot question and
it popped up a command prompt window saying it was updating TSM this may
take a while... please wait.
cyb!
-----Original Message-----
From: France, Don G (Pace) [mailto:[EMAIL PROTECTED]]
Sent: Thursday, September 21, 2000 1:11 PM
To: [EMAIL PROTECTED]
Subject: Re: TSM Upgrade
In the tradition of ADSM, I would avoid the first release; we waited until
373 for the first TSM, now I recommend the 4.1.1 level, BUT only if you need
a new feature only found in 4.1.
We've been running 373 with 372.01 clients on Win2K servers for the past 6
weeks, on two separate environments. Did a 3rd server install on Win2k-Pro,
all went (mostly) smoothly. The NT-device config for Dell-120T needed help
setting the element number, but that was the only "glitch" we've seen, so
far; the Dell-130T device-config was correct at the outset. Also, we've
installed 2 AIX servers with 373, one has 30 Solaris 372 clients and 5 NT
clients... all environments are installed and running okay. (Minor hang-ups
due to inadequate handling of Win2K System Objects, we're planning to use
NT-Backup to achieve "incremental" versions for restore, as in the old NT
days!)
Hope this helps.
Don France
Technical Architect, P.A.C.E.
San Jose, CA
mailto:[EMAIL PROTECTED]
PACE - http://www.pacepros.com
Bus-Ph: (408) 257-3037
-----Original Message-----
From: Remeta, Mark [mailto:[EMAIL PROTECTED]]
Sent: Thursday, September 21, 2000 8:51 AM
To: [EMAIL PROTECTED]
Subject: TSM Upgrade
Hello all, I just upgraded my ADSM 3.2.1.41 server to TSM 4.1.0.0. When I go
into the Server Utilities it says there is an error for Server1. When I try
and configure it in the Utilities wizard it doctor watsons out after I enter
the username and password. I am trying to manually start the service now but
it looks like I will have to go back to ADSM. It doesn't even log anything
in the Event viewer. Has anyone seen this behavior before???
Thanks for any help,
Mark Remeta
Seligman Data Corp.
100 Park Avenue
New York, NY 10017
Confidentiality Note: The information transmitted is intended only for the
person or entity to whom or which it is addressed and may contain
confidential and/or privileged material. Any review, retransmission,
dissemination or other use of this information by persons or entities other
than the intended recipient is prohibited. If you receive this in error,
please delete this material immediately.
Confidentiality Note: The information transmitted is intended only for the
person or entity to whom or which it is addressed and may contain
confidential and/or privileged material. Any review, retransmission,
dissemination or other use of this information by persons or entities other
than the intended recipient is prohibited. If you receive this in error,
please delete this material immediately.
