Actually you only need to stop the services if you are upgrading from an
older install. It should be fine having them running if it is a fresh
install and you are running the wizard. If they are not running the wizard
will ask if you want them started.
When you remmed out the names-pipe connection, did you enable another comm.
Method?
Chris Sharp
Senior Systems Engineer
MYND
Tel:- +44 (0)1932 879205
E-Mail:- [EMAIL PROTECTED]
PLEASE NOTE THAT MY E-MAIL ADDRESS HAS CHANGED
-----Original Message-----
From: Toni Banire [mailto:[EMAIL PROTECTED]]
Sent: 15 August 2000 12:17
To: [EMAIL PROTECTED]
Subject: Re: Failed install
I must admit I am still quite new to TSM. Once I do the initial install do I
need to stop any services b4 I run th config wizard.
I edited the dsmserv.opt file and remmed out the named-pipe connection
method b4
I started the config wizard. This seemed to work ok.
I still can't figure ot why I needed to do this. Is this an NT thing. Unix
installs are quite straight forward. We don't get this problem.
TIA
Toni
