On Tue, Nov 16, 2010 at 8:09 PM, David Leimbach <leim...@gmail.com> wrote:

> Could sparse files be an issue?  Bloom always shows up wrong when I
> restart.
>

Nope... Didn't make a difference it seems.

I recreated my venti setup, and it starts ok.  I do a vac and an unvac, then
kill it and restart and get the following:

% venti/venti
2010/1116 20:44:14 venti: conf...2010/1116 20:44:14 err 4: read
/Users/dave/venti/disks/bloom offset 0x0 count 65536 buf 3800000 returned
65536: No such file or directory
venti/venti: can't load bloom filter: read /Users/dave/venti/disks/bloom
offset 0x0 count 65536 buf 3800000 returned 65536: No such file or
directory

bloom is definitely there though... Not sure what the no such file or
directory is referring to just yet.
-rw-r--r--  1 dave  wheel   33554432 Nov 16 20:42 bloom

I'll try without the bloom filter.


> On Tuesday, November 16, 2010, David Leimbach <leim...@gmail.com> wrote:
> > On Tuesday, November 16, 2010, Russ Cox <r...@swtch.com> wrote:
> >> On Tue, Nov 16, 2010 at 5:43 PM, David Leimbach <leim...@gmail.com>
> wrote:
> >>> I'm trying to figure out how to correctly sync a plan9port venti
> instance so
> >>> I can start it back up again and have it actually function :-).
> >>> using venti/sync doesn't appear to get the job done...
> >>
> >> It should.  Not using venti/sync should work too since
> >> vac etc all sync before hanging up.  The flushicache/flushdcache
> >> trick will make restarting a little faster, but it should not
> >> be necessary for correctness and shouldn't even be
> >> that much faster.
> >
> > I did a kill TERM... should the signal handler have cleaned up or was
> > I supposed to send HUP?
> >
> >
> >>
> >> Russ
> >>
> >>
> >
>

Reply via email to