On Mon, May 24, 2010 at 12:00:14AM +0100, Ethan Grammatikidis wrote: > Is it possible to limit the frame rate aux/vga sets? The reason I'm > asking is:
No idea. >> Whatever I use for monitor (vesa, vga) or vgasize, the >> screen just turns black and the led of the monitor is blinking. > > I've had quite a lot of CRT monitors in the past. Many of them were > detected as being more capable than they really were, so X would set the > frame rate too high. A black screen with blinking led was a common > symptom of that. The same box with the same CRT runs X in 1280x1024x16 (didn't try 1600x1200). Regarding Plan 9, I also tested it with: - a plain old VGA monitor: just a blank screen - a flat panel (vga connector): blank screen, "no signal" Can it be that this is a driver issue? I already tried to get more information using the -v and -V options of aux/vga. With -m vesa, I always got the following, no matter what resolution I asked: main->snarf vesa->snarf vmf 100 vmdf 0 vf1 0 vbw 0 main->load +vgactlw type vesa -vgactlw type vesa I also thought that I might get around it by using a specific bios-string (-b option to aux/vga) but I don't know what I could possibly use. What can I do to debug this further? Kind regards, -- Frank Lenaerts ---------------------------------------- fr...@inua.be
